- 87 The engine of the Case excavator shakes, knocks the cylinder, and emits a lot of smoke
- 88 The common rail pressure of the excavator increases abnormally, the engine shakes violently, and emits too much black smoke
- 89 The common rail pressure of the Case excavator is reduced to a low level
- Case excavator fault code 118 The voltage of the excavator engine water temperature sensor is too high, the engine emits black smoke at normal temperature, and the engine emits white smoke at low temperature
- 182 The voltage of the fuel temperature sensor of the Case excavator is too low, less than 0.1 volts
- 183 The voltage of the fuel temperature sensor of the excavator is high, higher than 4.85 volts
- Case excavator fault code 192 The common rail pressure of the Case excavator is low, less than 0.7 volts
- 193 The common rail pressure of the excavator is higher than 4.5 volts
- Case excavator fault code 201 The engine of the Case excavator vibrates, idles roughly, and the output is reduced
- 238 The voltage of the boost pressure sensor of the excavator is too high, higher than 4.9 volts, and there is black smoke
- 335 Case excavator crankshaft sensor has no signal, output is reduced, engine emits white smoke, excavator engine may shake or stop
- Case excavator fault code 336 Excavator crankshaft sensor pulse is out of sync, white smoke, and severe shaking
- 340 Case excavator camshaft has no signal, and the engine cannot be restarted after stopping
- 341 Case excavator camshaft signal pulse is out of sync, and the excavator cannot identify the cylinder after stopping Case excavator engine fault code Fault code analysis, fault manifestation
- 87 Case excavator engine shakes, knocks cylinders, and emits very large smoke
- 88 Excavator common rail pressure increases abnormally, the engine shakes severely, and emits too much black smoke
- 89 Case excavator common rail pressure decreases to a low level
- Case excavator fault code 118 Excavator engine water temperature sensor voltage is too high, the engine emits black smoke at normal temperature, and the engine emits white smoke at low temperature
- 182 Case excavator fuel temperature sensor voltage is too low, less than 0.1 volt
- 183 The voltage of the fuel temperature sensor of the excavator is too high, higher than 4.85 volts
- Case excavator fault code 192 Case excavator common rail pressure is too low, lower than 0.7 volts
- 193 Excavator common rail pressure is higher than 4.5 volts
- Case excavator fault code 201 Case excavator engine vibration, rough idling, and reduced output
- 238 Excavator boost pressure sensor voltage is too high, higher than 4.9 volts, and there is black smoke
- 335 Case excavator crankshaft sensor has no signal, output is reduced, the engine emits white smoke, and the excavator engine may shake or stop
- Case excavator fault code 336 Excavator crankshaft sensor pulse is out of sync, white smoke, and shaking violently
- 340 Case excavator camshaft has no signal, and the engine cannot be restarted after stopping
- 341 Case excavator camshaft signal pulse is out of sync, and the excavator cannot identify cylinder v after stopping
